Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Hyundai >> 2003 >> Accent Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 12 (Fuel System (3.5L)) >> Fuel Delivery System >> Accelerator Pedal >> Installation

Accelerator Pedal: Installation

WARNING: This page is about a different car, the 2004 Hyundai Santa Fe and 2003 Hyundai Santa Fe. However, it is still accessible from the selected car via links, so may be relevant.
  1. When installing the return spring and accelerator arm, apply multi-purpose grease around each moving point of the accelerator arm.
  2. Apply sealant to the bolt mounting hole and tighten the accelerator arm bracket.

    Tightening torque 

    Accelerator arm bracket bolts:

    8~12 Nm (80~120 kg.cm, 6~7 lb.ft)

    Fig 1: Identifying Accelerator Cable & Arm
    G00790737Courtesy of HYUNDAI MOTOR CO.
  3. Securely install the resin bushing of the accelerator cable on the end of the accelerator arm.
scientia non olet · About Mike's Workshop Manuals