Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Hyundai >> 2002 >> Sonata Base, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Automatic Transaxle System) >> Automatic Transaxle System >> Service Adjustment Procedures >> Differential Case Preload Adjustment

Differential Case Preload Adjustment

WARNING: This page is about a different variant/trim than selected.

Place a solder (approx. 10 mm in length, 3 mm in diameter) on the torque converter housing as shown in the figure.

Install the torque converter housing to the transmission case without applying sealant. Tighten its mounting bolts to the specified torque. Loosen the bolts, and remove the solder. Use a micrometer to measure the thickness (T) of the pressed solder. Select a-spare which thickness is within the following value.

  1. Standard value: (T+0.045 mm) to (T+0.105 mm)
    Fig 1: Identifying Solder Location On Torque Converter Housing
    G01153979Courtesy of HYUNDAI MOTOR CO.
Fig 2: Measuring Piece Of Solder
G01153980Courtesy of HYUNDAI MOTOR CO.
scientia non olet · About Mike's Workshop Manuals