Cruise Control Main Switch

Remove cruise control main switch and disconnect harness connector. Check continuity between indicated switch terminals, with switch in appropriate position. See MAIN SWITCH CONTINUITY TEST . SeeFig 1 . If continuity is not as specified, replace cruise control main switch.

MAIN SWITCH CONTINUITY TEST

Switch Position

⁽¹⁾ Continuity Between Terminals No.

1 & 4; 2, 5 & 6

Off

1 & 4; 2 & 5

⁽¹⁾	Terminals No. 1 and 4 are for switch illumination circuit and should always have continuity. Also, terminals No. 2 and 5 are for illumination with switch in on position and should always have continuity.

Fig 1: Identifying Cruise Control System Main Switch Terminals

Courtesy of HYUNDAI MOTOR CO.