Band & Boot Identification

WARNING: This page is about a different car, the 1993 Mitsubishi 3000GT and 1993 Dodge Stealth. However, it is still accessible from the selected car via links, so may be relevant.

Band identification numbers are stamped on inside edge of band. See Fig 1. Boot identification numbers are stamped on largest ridge of boot. See BAND & BOOT APPLICATION table.

NOTE: The following are possible types of Constant Velocity (CV) joints used on axle shaft: Birfield Joint (BJ), Double Offset Joint (DOJ), Rzeppa Joint (RJ) and Tripod Joint (TJ). Determine type of CV joint used prior to disassembly. See AXLE SHAFT SPECIFICATIONS table. Note type of boot and location prior to removal. See BAND & BOOT APPLICATION table. Install a NEW retaining ring each time axle shaft is removed from transaxle.

Fig 1: Locating Band & Boot Identification Numbers

Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.

BAND & BOOT APPLICATION

Application

Large Band

Small Band

Boot

FWD

SOHC

⁽¹⁾

20-131

20-72

⁽¹⁾

DOHC

⁽¹⁾

20-131L

20-72

⁽¹⁾

AWD

⁽¹⁾

20-131

20-72

⁽¹⁾

⁽¹⁾	Boots and bands are packaged as a kit. Kits are broken down by type of joint. No specifications/identification numbers given by manufacturer.