Throttle Control Cable Adjustment
- Ensure throttle lever of carburetor is in curb idle position,
with engine at normal operating temperature. Raise cover "B" of
throttle cable upward to expose nipple. See Fig 1
. Loosen lower cable
bracket mounting bolt.
- Move lower cable bracket until distance between nipple and top
of cover "A" on throttle cable is .02-.06" (.95-1.05 mm). Tighten
lower cable bracket mounting bolt to 106-124 INCH lbs. (12-14 N.m).
With throttle lever in wide-open position, pull cable further upward
to ensure cable is free.
Courtesy of HYUNDAI MOTOR CO.