Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Hyundai >> 1986 >> Excel Base, 2D Hatchback >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Servicing - A/T) >> Adjustments >> Throttle Control Cable Adjustment

Throttle Control Cable Adjustment

WARNING: This page is about a different variant/trim than selected.
  1. Check to ensure that throttle lever of carburetor is in curb idle position, with engine coolant at normal operating temperature 180-190°F (80-90°C). Raise cover "B" of throttle cable upward to expose nipple. Loosen lower cable bracket mounting bolt.
  2. Move lower cable bracket until distance between nipple and top of cover "A" on throttle cable is adjusted to .02-.06" (.95-1.05 mm). Tighten lower cable bracket mounting bolt to 9-10.5 ft. lbs. (12-14 N.m). With throttle lever in wide-open position, pull cable further upward to confirm cable has freedom of movement. See Fig 1 .
Fig 1: Adjusting Throttle Control Cable
G82812Courtesy of HYUNDAI MOTOR CO.
scientia non olet · About Mike's Workshop Manuals