Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Hummer >> 2010 >> H3T Base, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 23 (Battery, Charging System And Starting System) >> Repair Instructions >> Battery Replacement (LLV/LLR) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2010 GMC Canyon and 2010 Chevrolet Colorado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Battery & Battery Retainer
    GM1313643Courtesy of GENERAL MOTORS CORP.
  1. Install the battery (4) into the lower battery box (5).
  2. Install the battery retainer (1) and washer (2).
    3. CAUTION: Refer to Fastener Caution .
  3. Install the battery retainer nut (3) and tighten to 15 N.m (11 lb ft).
    4. Fig 2: View Of Battery Box
    GM1313644Courtesy of GENERAL MOTORS CORP.
  4. Install the upper battery box (2) over the battery, engage the locking tabs (1) into the lower battery box (3).
  5. Connect the battery vent duct to the upper battery box (2).
    6. Fig 3: View Of Battery Cables
    GM1313634Courtesy of GENERAL MOTORS CORP.
  6. Clean any existing corrosion from the battery terminal and battery cable using a wire brush.
  7. Connect the battery positive cable to the battery and tighten the battery cable nut (4) to 9 N.m (80 lb in).
  8. Close the protective cover (3) over the battery positive cable terminal.
  9. Connect the battery negative cable. Refer to Battery Negative Cable Disconnection and Connection .
scientia non olet · About Mike's Workshop Manuals