Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Hummer >> 2010 >> H3 Base, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 69 (Engine Control System & Fuel System - 5.3L - DTC P0010 To DTC P0232/P025A) >> DTC P025A >> Circuit/System Testing

Circuit/System Testing

WARNING: This page is about a different car, the 2010 GMC Canyon and 2010 Chevrolet Colorado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition OFF, disconnect the harness connector at the K27 fuel pump control module.
  2. Ignition OFF, connect a test lamp between the control circuit terminal 13 and ground.
  3. Ignition ON, command the fuel pump ON and OFF with a scan tool. The test lamp should turn ON and OFF when changing between the commanded states.
    • If the test lamp is always ON, test the control circuit for a short to voltage. If the circuit tests normal, replace the K20 ECM.
    • If the test lamp is always OFF, test the control circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace the K20 ECM.
  4. If all circuits test normal, replace the K27 fuel pump control module.
scientia non olet · About Mike's Workshop Manuals