Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Hummer >> 2010 >> H3 Base, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 69 (Engine Control System & Fuel System - 5.3L - DTC P0010 To DTC P0232/P025A) >> DTC P0116 >> Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different car, the 2010 GMC Canyon and 2010 Chevrolet Colorado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition OFF, inspect the cooling system surge tank for the proper coolant level. Refer to Cooling System Leak Testing and Cooling System Draining and Filling (Static Fill) or Cooling System Draining and Filling (Vac N Fill) .
  2. Ignition OFF for 8 hours or greater.
  3. Ignition ON, observe the scan tool IAT and ECT sensor parameters. The ECT, IAT, and ambient temperature should be within 6°C (11°F) of each other.
  4. Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
scientia non olet · About Mike's Workshop Manuals