Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Hummer >> 2010 >> H3 Base, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 6 (Interior Trim System And Paneling) >> Repair Instructions >> Assist Handle Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2010 GMC Canyon and 2010 Chevrolet Colorado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the assist handle over the retaining clips.
    2. Fig 1: View Of Assist Handle
    GM1364955Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to Fastener Caution .
  2. Install the assist handle by installing 2 screws and washers into the retaining clips. Tighten the assist handle screws to 1.2 N.m (10 lb in).
    3. Fig 2: View Of Coat Hook Assembly
    GM1276792Courtesy of GENERAL MOTORS CORP.
  3. In replacing the entire coat hook assembly, press the coat hook and the retaining clip as an assembly into the sheet metal opening until the clip locks into position.
scientia non olet · About Mike's Workshop Manuals