Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Hummer >> 2010 >> H3 Base, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 46 (Power Steering System) >> Repair Instructions >> Power Steering Pump Bracket Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2010 GMC Canyon and 2010 Chevrolet Colorado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Removing/Installing Power Steering Pump Bracket
    GM1201382Courtesy of GENERAL MOTORS CORP.
  1. Install the power steering pump bracket.
    2. CAUTION: Refer to Fastener Caution .
  2. Install the power steering pump bracket mounting bolts and tighten to 50 N.m (37 lb ft).
  3. Install the drive belt tensioner. Refer to Drive Belt Tensioner Replacement for the 2.9L engine or Drive Belt Tensioner Removal for the 3.7L engine.
  4. Install the power steering pump. Refer to Power Steering Pump Replacement (LLV, LLR)  or Power Steering Pump Replacement (LH8) .
scientia non olet · About Mike's Workshop Manuals