Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Hummer >> 2010 >> H3 Base, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 23 (Battery, Charging System And Starting System) >> Repair Instructions >> Generator Bracket Replacement (LH8) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2010 GMC Canyon and 2010 Chevrolet Colorado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Generator Bracket & Bolts
    GM847280Courtesy of GENERAL MOTORS CORP.
  1. Install the generator bracket.
    2. CAUTION: Refer to Fastener Caution .
  2. Install the generator bracket bolts and tighten to 50 N.m (37 lb ft).
    3. Fig 2: Engine Wiring Harness Electrical Connectors, Harness Bracket & Bracket Nut
    GM1897775Courtesy of GENERAL MOTORS CORP.
  3. Position the engine wiring harness bracket to the generator bracket.
  4. Install the engine wiring harness bracket bolt (4) and tighten to 40 N.m (29.5 lb ft).
  5. Install the drive belt idler pulley. Refer to Drive Belt Idler Pulley Replacement .
  6. Install the power steering pump. Refer to Power Steering Pump Replacement (LH8) .
  7. Install the generator. Refer to Generator Replacement (LH8) .
scientia non olet · About Mike's Workshop Manuals