Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Hummer >> 2009 >> H3 Alpha >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Manual Transmission) >> Repair Instructions - On Vehicle >> Control Lever and/or Boot Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Remove the shift lever assembly. Refer to Shift Lever Assembly Replacement .
    2. Fig 1: Control Lever Boot Removal/Installation
    GM1563256Courtesy of GENERAL MOTORS CORP.
  2. Remove the control lever boot screws (1).
  3. Tilt and remove the control lever boot (2) from the control lever.
  4. Shift the transmission into NEUTRAL.
    5. Fig 2: Control Lever Housing Assembly Removal/Installation
    GM1563260Courtesy of GENERAL MOTORS CORP.
  5. Remove the control lever housing assembly bolts (1).
  6. Remove the control lever housing assembly (2) and gasket (3).
  7. Mask off the control lever housing opening, in order to prevent foreign objects from entering the transmission.
  8. Disassemble the control lever housing if necessary. Refer to Shift Control Housing Disassemble .
scientia non olet · About Mike's Workshop Manuals