Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Hummer >> 2009 >> H3 Alpha >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Controls And Fuel - 3.7L - Introduction) >> Repair Instructions >> Fuel Line Replacement - Chassis >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
WARNING: Refer to Fuel and Evaporative Emission Pipe Warning .
WARNING: Refer to Gasoline/Gasoline Vapors Warning .
CAUTION: Refer to Fuel and Evaporative Emission Hose/Pipe Connection Cleaning Caution .
    Fig 1: Identifying Fuel Feed Lines, Connections & Clips
    GM1560094Courtesy of GENERAL MOTORS CORP.
  1. Relieve the fuel system pressure. Refer to Fuel Pressure Relief (With CH 48027)  or Fuel Pressure Relief (Without CH 48027) .
  2. Disengage the quick connect fitting lock clip (1).
  3. Disconnect the fuel feed line quick connect (2). Refer to Metal Collar Quick Connect Fitting Service .
  4. Open the retaining clips (3, 4).
  5. Remove fuel feed line from the clips.
  6. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  7. Disconnect the fuel feed line from the fuel tank. Refer to Plastic Collar Quick Connect Fitting Service .
    8. Fig 2: Locating EVAP Lines & Clips At Automatic Transmission
    GM1560090Courtesy of GENERAL MOTORS CORP.
  8. If equipped with an automatic transmission, open the retaining clips attaching the lines to the transmission.
  9. Remove the fuel feed line from the clips.
    10. Fig 3: Locating EVAP Lines & Clips At Manual Transmission
    GM1560089Courtesy of GENERAL MOTORS CORP.
  10. If equipped with a manual transmission, open the retaining clips attaching the lines to the transmission.
  11. Remove the fuel feed line from the clips.
scientia non olet · About Mike's Workshop Manuals