Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Hummer >> 2009 >> H3 Alpha >> Repair and Diagnosis >> External Pages >> Different car >> Section 249 (Engine Controls And Fuel - 5.3L, 6.0L & 6.2L - Repair Instructions) >> Repair Instructions >> Manifold Absolute Pressure Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:

Lightly coat the MAP sensor seal with clean engine oil before installing the sensor.

    Fig 1: MAP Sensor And Retainer
    GM1697060Courtesy of GENERAL MOTORS CORP.
  1. Install the MAP sensor.
  2. Install the MAP sensor retainer.
    3. Fig 2: Engine Harness Retainer Nut And Electrical Connectors
    GM1696891Courtesy of GENERAL MOTORS CORP.
  3. Connect the engine harness wiring electrical connector (4) to the MAP sensor.
  4. Install the intake manifold sight shield. Refer to Upper Intake Manifold Sight Shield Replacement .
scientia non olet · About Mike's Workshop Manuals