Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Hummer >> 2008 >> H3 Base, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Controls And Fuel - 5.3L - Introduction (2 Of 2)) >> Repair Instructions >> Fuel Level Sensor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Fuel Tank Module
    GM1564238Courtesy of GENERAL MOTORS CORP.
  1. Remove the fuel tank module. Refer to Fuel Tank Fuel Pump Module Replacement .
  2. Disconnect the fuel level sensor electrical connector (1) from the module cover.
    3. Fig 2: Fuel Level Sensor
    GM1564239Courtesy of GENERAL MOTORS CORP.
  3. Complete the following in order to remove the fuel level sensor (1) from the module bucket:
    1. Disengage the locking tabs on the sensor.
    2. Slide the sensor upward from the bucket.
scientia non olet · About Mike's Workshop Manuals