Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Hummer >> 2008 >> H3 Base, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 99 (Wiring Systems And Power Management - Introduction) >> Repair Instructions >> Ignition and Start Switch Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Chevrolet Malibu Classic. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Ignition Switch Bracket
    GM1207709Courtesy of GENERAL MOTORS CORP.
  1. Install the ignition switch bracket.
  2. Install the theft deterrent control module. Refer to Theft Deterrent Module Replacement .
    3. NOTE: Refer to Fastener Notice .
  3. Install the ignition switch bracket screws.

    Tighten:  Tighten the screws to 5 N.m (44 lb in).

    4. Fig 2: View Of Ignition Switch Assembly
    GM1207704Courtesy of GENERAL MOTORS CORP.
  4. Install the ignition switch.
  5. Tighten the ignition switch screws.

    Tighten:  Tighten the screws to 2.5 N.m (22 lb in).

  6. Connect the park lock cable at the ignition switch. Refer to Park Lock Cable Replacement .
  7. Install the theft deterrent module wire harness connector.
  8. Install the ignition switch wire harness connector.
  9. Install the ignition switch lock cylinder. Refer to Ignition Switch Lock Cylinder Replacement .
  10. Install the I/P center trim panel. Refer to Instrument Panel Center Trim Panel Replacement .
  11. Install the knee bolster. Refer to Knee Bolster Replacement .
  12. Install the I/P cluster. Refer to Instrument Cluster Replacement .
scientia non olet · About Mike's Workshop Manuals