Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Hummer >> 2008 >> H3 Base, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 504 (Engine Cooling System) >> Repair Instructions >> Radiator Replacement (LLT) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2010 Cadillac STS. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the radiator.
  2. Connect the upper air baffle retaining pins to the radiator.
    3. Fig 1: Radiator Support Bracket & Bolts
    GM2147044Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to Fastener Caution .
  3. Install the radiator support brackets (2).
  4. Install the radiator support bracket bolts (1) and tighten to 9 N.m (80 lb in).
    5. Fig 2: Auxiliary Water Pump Outlet Hose & Clamp
    GM2147287Courtesy of GENERAL MOTORS CORP.
  5. Connect the auxiliary water pump outlet hose to the radiator (2). Use J 38185:  Hose Clamp Pliers to position the auxiliary water pump outlet hose clamp (1) to secure the hose.
    6. Fig 3: Surge Tank Inlet Hose & Clamp
    GM2147049Courtesy of GENERAL MOTORS CORP.
  6. Connect the surge tank inlet hose (2) to the radiator. Use J 38185:  Hose Clamp Pliers to position the surge tank inlet hose clamp (1) to secure the hose.
    7. Fig 4: Radiator Inlet Hose & Clamp
    GM2147172Courtesy of GENERAL MOTORS CORP.
  7. Connect the radiator inlet hose (2) to the radiator. Use J 38185:  Hose Clamp Pliers to position the radiator inlet hose clamp (1) to secure the hose.
    8. Fig 5: Radiator Outlet Hose & Clamp
    GM2147246Courtesy of GENERAL MOTORS CORP.
  8. Connect the radiator outlet hose (2) to the radiator. Use J 38185:  Hose Clamp Pliers to position the radiator outlet hose clamp (1) to secure the hose.
  9. Raise and support the vehicle.
    10. Fig 6: Transmission Oil Cooler Mounting Bolts
    GM2147033Courtesy of GENERAL MOTORS CORP.
  10. Install the TOC mounting bolts (1) and tighten to 5 N.m (44 lb in).
  11. Connect the lower retaining pins of the side air baffle to the radiator.
    12. Fig 7: Lower Condenser Mounting Bolts
    GM2147030Courtesy of GENERAL MOTORS CORP.
  12. Install the lower condenser mounting bolts (1) and tighten to 5.4 N.m (48 lb in).
    13. Fig 8: Upper Condenser Mounting Bolts
    GM2147029Courtesy of GENERAL MOTORS CORP.
  13. Install the upper condenser mounting bolts (1) and tighten to 5.4 N.m (48 lb in).
  14. Install the electric cooling fan. Refer to Engine Coolant Fan Replacement (LH2 without V03, LLT) .
  15. Fill the cooling system. Refer to Cooling System Draining and Filling (Static Fill)  or Cooling System Draining and Filling (GE 47716) .
scientia non olet · About Mike's Workshop Manuals