Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Hummer >> 2008 >> H3 Base, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 467 (Battery, Charging System And Starting System) >> Repair Instructions >> Generator Bracket Replacement (LLT) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2010 Cadillac STS. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Generator Bracket Bolts
    GM887707Courtesy of GENERAL MOTORS CORP.
  1. Install the generator bracket.
  2. Install the generator bracket bolts.
    3. CAUTION: Refer to Fastener Caution .
  3. Tighten the generator bracket bolts (1, 2) to 50 N.m (37 lb ft).
  4. Tighten the generator bracket bolt (3) to 23 N.m (17 lb ft).
  5. Install the belt tensioner. Refer to Water Pump and Generator Belt Tensioner Replacement .
  6. Install the coolant inlet pipe lower bolt from the generator bracket.
  7. Install the generator. Refer to Generator Replacement (LLT) .
scientia non olet · About Mike's Workshop Manuals