Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Hummer >> 2008 >> H3 Base, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 38 (Hydraulic Brake System) >> Repair Instructions >> Brake Fluid Level Indicator Switch Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2008 Isuzu i-370, 2008 Isuzu i-290, 2008 GMC Canyon, and 2008 Chevrolet Colorado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the electrical connector from the sensor.
  2. Using a pair of needle nose pliers bend on a 90 degree angle, release the retaining clip.
  3. Remove the sensor from the master cylinder.
scientia non olet · About Mike's Workshop Manuals