Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Hummer >> 2008 >> H3 Base, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 33 (Wiring Systems And Power Management - Introduction) >> Repair Instructions >> Ignition and Start Switch Replacement

Ignition and Start Switch Replacement

WARNING: This page is about a different car, the 2008 Isuzu i-370, 2008 Isuzu i-290, 2008 GMC Canyon, and 2008 Chevrolet Colorado. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Ignition and Start Switch Replacement
GM1749570Courtesy of GENERAL MOTORS CORP.
Ignition and Start Switch Replacement

Callout Component Name

Preliminary Procedures

  1. Disable the supplemental inflatable restraint (SIR) system. Refer to SIR Disabling and Enabling .
  2. Disconnect the battery negative cable. Refer to Battery Negative Cable Disconnection and Connection .
  3. Remove the lower steering column trim cover. Refer to Steering Column Trim Covers Replacement .
1 Ignition/Start Switch Electrical Connector
2 Ignition/Start Switch Bolt (Qty: 2)
NOTE: Refer to Fastener Notice .

Tighten:  0.74 N.m (7 lb in)
3 Ignition/Start Switch
Procedure: 
Turn the ignition lock cylinder to the run position prior to removing the ignition/start switch.
scientia non olet · About Mike's Workshop Manuals