Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Hummer >> 2008 >> H3 Base, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 264 (Lighting Systems) >> Diagnostic Information and Procedures >> DTC B2585 >> Circuit/System Testing

Circuit/System Testing

WARNING: This page is about a different car, the 2009 GMC Canyon and 2009 Chevrolet Colorado. However, it is still accessible from the selected car via links, so may be relevant.

Park Lamp Malfunction

  1. Ignition OFF, disconnect the park lamp relay.
  2. Connect a test lamp between the relay coil control circuit terminal 86 and B+.
  3. Ignition ON, command the Park Lamps ON and OFF with a scan tool. The test lamp should turn ON and OFF..
    • If the test lamp is always ON, test the control circuit for a short to ground. If the circuit tests normal, replace the BCM.
    • If the test lamp is always OFF, test the control circuit for a short to voltage or an open/high resistance. If the circuit tests normal, replace the BCM.
  4. If all circuits test normal, test or replace the relay.
scientia non olet · About Mike's Workshop Manuals