Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Hummer >> 2008 >> H3 Base, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 22 (Battery, Charging System And Starting System) >> Repair Instructions >> Starter Motor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Isuzu i-370, 2008 Isuzu i-290, 2008 GMC Canyon, and 2008 Chevrolet Colorado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Starter Motor
    GM1313646Courtesy of GENERAL MOTORS CORP.
  1. Position the starter motor (3) over the stud (2).
    2. NOTE: Refer to Fastener Notice .
  2. Install the starter motor mounting nut (1) and bolt (4).

    Tighten:  Tighten the bolt/nut to 50 N.m (37 lb ft).

    3. Fig 2: View Of Battery Positive Cable At Starter
    GM1313639Courtesy of GENERAL MOTORS CORP.
  3. Connect the battery positive cable (2) to the starter and install the starter terminal nut (1)

    Tighten:  Tighten the nut to 9 N.m (80 lb in).

  4. Connect the lead (4) to the starter solenoid and install the starter solenoid S terminal nut (3).

    Tighten:  Tighten the nut to 3.5 N.m (31 lb in).

  5. Install the intake manifold. Refer to Intake Manifold Replacement or Intake Manifold Replacement .
scientia non olet · About Mike's Workshop Manuals