Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Hummer >> 2008 >> H3 Base, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 22 (Battery, Charging System And Starting System) >> Diagnostic Information and Procedures >> DTC B151B >> Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different car, the 2008 Isuzu i-370, 2008 Isuzu i-290, 2008 GMC Canyon, and 2008 Chevrolet Colorado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Verify that the GBCM is installed correctly. The GBCM should be installed on the negative battery cables, with the sensor coil around the negative cables and facing away from the battery, and with the harness connector facing toward the battery.
    • If the GBCM is installed backwards or incorrectly, remove and reinstall the GBCM.
  2. Ignition ON, clear the DTC with the scan tool. Verify that DTC B151B does not set.
    • If the DTC sets, replace the GBCM.
scientia non olet · About Mike's Workshop Manuals