Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Hummer >> 2008 >> H3 Base, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 19 (Engine Control System & Fuel System - 3.7L - Introduction (2 Of 2)) >> Repair Instructions >> Accelerator Pedal Position Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Isuzu i-370, 2008 GMC Canyon, and 2008 Chevrolet Colorado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of APP Sensor
    GM1352013Courtesy of GENERAL MOTORS CORP.
  1. Position the APP sensor over the studs.
    2. NOTE: Refer to Fastener Notice .
  2. Install the APP sensor nuts.

    Tighten:  Tighten the APP sensor mounting nuts to 9 N.m (80 lb in).

  3. Connect the APP sensor electrical connector.
  4. Inspect below the pedal for binding, to ensure full range of motion.
scientia non olet · About Mike's Workshop Manuals