Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Hummer >> 2008 >> H3 Base, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 175 (Wiper System & Washer System) >> Repair Instructions >> Windshield Wiper Transmission Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Cadillac STS. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Pivot Arms & Drive Links
    GM781424Courtesy of GENERAL MOTORS CORP.
  1. Position the transmission drive links (4) to the pivot arms (3,5).
    2. Fig 2: Installing Wiper Transmission To Wiper Motor Crank Arm
    GM306515Courtesy of GENERAL MOTORS CORP.
  2. Install the drive links onto the wiper motor crank arm and the wiper transmission drive shafts with the J 39529  . See Special Tools .
    3. Fig 3: View Of Windshield Wiper Motor Components
    GM776830Courtesy of GENERAL MOTORS CORP.
  3. Install the wiper motor module assembly Refer to Windshield Wiper System Module Replacement .
    4. Fig 4: View Of Wiper Arm Components
    GM776832Courtesy of GENERAL MOTORS CORP.
  4. Install the air inlet grille panel. Refer to Air Inlet Grille Panel Replacement .
  5. Install the wiper arms (1,4). Refer to Windshield Wiper Arm Replacement .
  6. Operate the wipers and check for proper operation.
scientia non olet · About Mike's Workshop Manuals