Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Hummer >> 2008 >> H3 Base, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 168 (Cellular System, Entertainment System, And Navigation System) >> Repair Instructions >> Navigation Antenna Coaxial Cable Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2008 Cadillac STS. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Coax Cable Under Side Sail Panel
    GM1830233Courtesy of GENERAL MOTORS CORP.
  1. Remove the passenger side sail panel. Refer to Sail Panel Replacement .
  2. Lower the rear of the headliner to gain access to the coax cable. Refer to Headlining Trim Panel Replacement .
    3. Fig 2: View Of Right Rear Compartment
    GM1830205Courtesy of GENERAL MOTORS CORP.
  3. Remove the right rear compartment trim.
  4. Disconnect the coax cable connectors.
    IMPORTANT: If replacing the cable with a new one cut the connector ends off and leave the old cable installed in the wire harness.
  5. Remove the coax cable.
scientia non olet · About Mike's Workshop Manuals