Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Hummer >> 2008 >> H3 Base, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 121 (Wiper System & Washer System) >> Repair Instructions >> Windshield Wiper Motor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Chevrolet Malibu Classic. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Wiper Motor Assembly
    GM1206780Courtesy of GENERAL MOTORS CORP.
  1. Install the wiper motor module support bracket (4) to the wiper motor (3). Refer to Wiper Motor Module Support Bracket Replacement .
  2. Position the wiper motor (3) to the wiper drive system module (2).
  3. Position the spacer (1) to the wiper drive system module (2).
    4. NOTE: Refer to Fastener Notice .
  4. Install the 2 wiper motor bolts.

    Tighten:  Tighten the bolts to 4.5 N.m (40 lb in).

    5. Fig 2: Identifying Wiper Transmission And Wiper Motor Crank Arm
    GM306515Courtesy of GENERAL MOTORS CORP.
  5. Install the wiper transmission links onto the wiper motor crank arm with the J 39529  . See Special Tools .
    6. Fig 3: View Of Wiper Drive System Module
    GM1201895Courtesy of GENERAL MOTORS CORP.
  6. Install the wiper drive system module. Refer to Windshield Wiper System Module Replacement .
  7. Install the air inlet grille panel. Refer to Air Inlet Grille Panel Replacement .
  8. Install the wiper arms. Refer to Windshield Wiper Arm Replacement .
  9. Inspect the washers for proper operation.
scientia non olet · About Mike's Workshop Manuals