Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Hummer >> 2008 >> H3 Base, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 121 (Wiper System & Washer System) >> Repair Instructions >> Windshield Wiper Arm Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Chevrolet Malibu Classic. However, it is still accessible from the selected car via links, so may be relevant.
    IMPORTANT: The wiper arm nut must be hand-started to avoid cross-threading.
    Fig 1: Identifying Wiper Blade Alignment Marks
    GM872389Courtesy of GENERAL MOTORS CORP.
  1. Install the wiper arm onto the wiper module pivot shaft.
  2. Align the wiper blade to the wiper dots on the windshield.
    3. Fig 2: View Of Windshield Wiper Components
    GM1201865Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  3. Install the wiper arm nut. Hold the wiper arm to the wiper dot as you tighten the nut.

    Tighten:  Tighten the nut to 35 N.m (25 lb ft).

  4. Install the wiper arm nut finish cap.
    5. Fig 3: Identifying Washer Hose Connectors And Air Inlet Grille Panel
    GM1202124Courtesy of GENERAL MOTORS CORP.
  5. Connect the wiper arm washer hose connectors to the air inlet grille panel.
  6. Operate the windshield wipers and inspect for proper operation.
  7. Close the hood.
scientia non olet · About Mike's Workshop Manuals