Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Hummer >> 2008 >> H3 Base, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 121 (Wiper System & Washer System) >> Repair Instructions >> Washer Pump Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Chevrolet Malibu Classic. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Exploded View Of Washer Solvent Container
    GM1207514Courtesy of GENERAL MOTORS CORP.
  1. Position the washer pump seal (6) to the washer solvent container (1), pressing in until fully seated.
  2. Position the washer pump (5) to the washer solvent container (1) pressing in until fully seated.
  3. Connect the washer pump electrical connector.
  4. Connect the washer pump hose (2) to the washer pump (5)..
  5. Install the front fender liner. Refer to Front Fender Liner Replacement .
  6. Fill the washer solvent container with washer solvent.
  7. Inspect the washers for proper operation.
scientia non olet · About Mike's Workshop Manuals