Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Hummer >> 2008 >> H3 Base, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 116 (Adjustable Pedal System) >> Repair Instructions >> Accelerator Pedal Bracket Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Chevrolet Malibu Classic. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Nuts Attaching Adjustable Accelerator Bracket To Cowl
    GM1241586Courtesy of GENERAL MOTORS CORP.
  1. Install the adjustable accelerator bracket to the vehicle.
    2. NOTE: Refer to Fastener Notice .
    IMPORTANT: Ensure that the adjustable accelerator pedal and adjustable brake pedal are synchronized in the full rearward position.
  2. Install the 3 adjustable accelerator bracket nuts.

    Tighten:  Tighten the nuts to 10 N.m (89 lb in).

  3. Install the NEW cable. Refer to Brake Pedal Adjuster Actuator Cable Replacement .
  4. Install the accelerator pedal to the vehicle. Refer to Accelerator Pedal Assembly Replacement .
  5. Calibrate the brake pedal position sensor. Refer to Brake Pedal Position Sensor Calibration .
scientia non olet · About Mike's Workshop Manuals