Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Hummer >> 2008 >> H3 Base, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 114 (Power Steering System) >> Repair Instructions >> Power Steering Pump Flow Control Valve Replacement - Off Vehicle >> Assembly Procedure

Assembly Procedure

WARNING: This page is about a different car, the 2008 Chevrolet Malibu Classic. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Power Steering Pump Flow Control Valve
    GM1776816Courtesy of GENERAL MOTORS CORP.
  1. Install the flow control spring (2) into the power steering pump housing (1).
  2. Install the control valve assembly (3) into the power steering pump housing (1).
  3. Lubricate the O-ring seal (4) with power steering fluid.
  4. Install the O-ring seal (4) onto the O-ring seat on the union fitting (5).
    5. NOTE: Refer to Fastener Notice .
  5. Install the O-ring union fitting (5) to the power steering pump housing (1).

    Tighten:  Tighten the fitting (5) to 75 N.m (55 lb ft).

scientia non olet · About Mike's Workshop Manuals