Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Hummer >> 2008 >> H3 Base, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 405 (Engine Controls And Fuel - 4.6L - Introduction) >> Repair Instructions >> Knock Sensor 1 Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2009 Cadillac STS. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Intake Manifold & Bolts
    GM928175Courtesy of GENERAL MOTORS CORP.
  1. Remove the intake manifold. Refer to Intake Manifold Replacement .
    2. Fig 2: View Of Knock Sensors & Electrical Connectors
    GM1284306Courtesy of GENERAL MOTORS CORP.
  2. Disconnect the knock sensor (KS) electrical connector (2).
  3. Remove the KS bolt.
  4. Remove the KS (1).
scientia non olet · About Mike's Workshop Manuals