Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Hummer >> 2008 >> H3 Base, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 405 (Engine Controls And Fuel - 4.6L - Introduction) >> Repair Instructions >> Crankshaft Position Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2009 Cadillac STS. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Crankshaft Position Sensor & Bolt
    GM928205Courtesy of GENERAL MOTORS CORP.
    NOTE: Inspect the crankshaft sensor O-ring for wear or damage. If a problem is found, replace the O-ring.
  1. Lubricate the crankshaft sensor O-ring with clean engine oil.
    2. CAUTION: Refer to Fastener Caution .
  2. Install the crankshaft sensor and the retaining bolt and tighten to 10 N.m (89 lb in).
  3. Connect the crankshaft position sensor electrical connector.
  4. Install the intake manifold. Refer to Intake Manifold Replacement .
  5. Perform the Crankshaft Position System Variation Learn .
scientia non olet · About Mike's Workshop Manuals