Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Hummer >> 2008 >> H3 Base, Automatic >> Repair and Diagnosis >> Body & Frame >> Ignition Switch/Steering Lock >> Wiring Systems And Power Management - Introduction >> Repair Instructions >> Ignition Lock Cylinder Replacement >> Removal Procedure

Removal Procedure

  1. Remove the steering column trim covers. Refer to Steering Column Trim Covers Replacement .
  2. Turn the ignition lock cylinder to the accessory (ACC) position.
  3. The ignition lock cylinder access hole is just under the inflatable restraint steering wheel module coil on the right center of the steering column housing.
  4. Insert the 90 degree tip of a pick type tool into the ignition lock cylinder access hole.
  5. Push down and hold the ignition lock cylinder retaining pin.
  6. Remove the ignition lock cylinder by pulling it out of the steering column.
scientia non olet · About Mike's Workshop Manuals