Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Hummer >> 2008 >> H3 Base, Automatic >> Repair and Diagnosis >> Body & Frame >> Ignition Switch/Steering Lock >> Wiring Systems And Power Management - Introduction >> Repair Instructions >> Ignition Lock Cylinder Case Replacement >> Removal Procedure

Removal Procedure

    CAUTION: Refer to SIR Caution .
  1. Disable the supplemental inflatable restraint (SIR) system. Refer to SIR Disabling and Enabling .
  2. Remove the ignition lock cylinder. Refer to Ignition Lock Cylinder Replacement .
  3. Remove the multifunction turn signal switch housing. Refer to Multifunction Turn Signal Switch Housing Replacement .
    4. Fig 1: View Of Ignition Switch & Lock Housing Assembly
    GM1492304Courtesy of GENERAL MOTORS CORP.
  4. Remove the ignition lock cylinder case bolt using a hammer and chisel.
  5. Remove the ignition lock cylinder case.
scientia non olet · About Mike's Workshop Manuals