Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Hummer >> 2008 >> H3 Alpha >> Repair and Diagnosis >> External Pages >> Different car >> Section 146 (HVAC System - Automatic) >> Repair Instructions >> Mode Actuator Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Chevrolet Malibu Classic. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Mode Actuator Screws
    GM1203571Courtesy of GENERAL MOTORS CORP.
  1. Install the mode actuator.
    2. NOTE: Refer to Fastener Notice .
  2. Install the mode actuator screws.

    Tighten:  Tighten the screws to 1.5 N.m (13 lb in).

  3. Install the mode actuator wire harness connector.
  4. Close I/P compartment door. Refer to Instrument Panel Compartment Replacement .
  5. Install the fuse labeled HVAC CTRL (BATT).
scientia non olet · About Mike's Workshop Manuals