Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Hummer >> 2007 >> H3 Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 54 (Power Steering System) >> Repair Instructions >> Power Steering Pulley Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2005 GMC Canyon and 2005 Chevrolet Colorado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Power Steering Pump Pulley
    GM1201377Courtesy of GENERAL MOTORS CORP.
  1. Install the power steering pump pulley to the end of the power steering pump shaft.
    2. Fig 2: View Of Power Steering Pump Pulley Installer
    GM643361Courtesy of GENERAL MOTORS CORP.
  2. Install the power steering pump pulley to the power steering pump using J 25033-C  . See Special Tools .
    3. Fig 3: Checking Power Steering Pump Pulley Installed Depth
    GM245012Courtesy of GENERAL MOTORS CORP.
  3. Install the power steering pump pulley (1) flush against the end of the power steering pump shaft (2), with an allowable variance of 0.25 mm (0.010 in).
  4. Install the drive belt. Refer to Drive Belt Replacement (without A/C) or Drive Belt Replacement (with A/C) in Engine Mechanical - 2.8L or Drive Belt Replacement (without A/C) or Drive Belt Replacement (with A/C) in Engine Mechanical - 3.5L.
scientia non olet · About Mike's Workshop Manuals