Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Hummer >> 2007 >> H3 Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 54 (Power Steering System) >> Repair Instructions >> Power Steering Hose Assembly Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2005 GMC Canyon and 2005 Chevrolet Colorado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install a drain pan under the vehicle.
    2. NOTE: Refer to Power Steering Hose Disconnected Notice in Cautions and Notices.
    Fig 1: View Of Power Steering Pressure Hoses
    GM1207233Courtesy of GENERAL MOTORS CORP.
  2. Disconnect the power steering hose assembly from the power steering pump.
  3. Raise the vehicle and support with suitable safety stands. Refer to Lifting and Jacking the Vehicle in General Information.
    4. Fig 2: View Of Power Steering Hose Assembly
    GM1207235Courtesy of GENERAL MOTORS CORP.
  4. Remove the power steering hose assembly bracket retaining bolts.
  5. Remove the power steering hose assembly to the power steering gear retaining bolt.
  6. Disconnect the power steering hose assembly from the power steering gear.
  7. Remove the power steering hose assembly from the vehicle.
    8. NOTE: Clean the power steering gear inlet and outlet ports thoroughly of any debris. Failure to do so could result in contamination and damage to the power steering system components.
  8. Clean the power steering gear inlet and outlet ports of any debris.
scientia non olet · About Mike's Workshop Manuals