Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Hummer >> 2007 >> H3 Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 38 (Antilock Brake System And Traction Control System) >> Repair Instructions >> Brake Pressure Modulator Valve (BPMV) Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2005 GMC Canyon and 2005 Chevrolet Colorado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of BPMV & Mounting Bracket
    GM1384684Courtesy of GENERAL MOTORS CORP.
  1. Install the BPMV to the mounting bracket.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Tighten the mounting nuts.

    Tighten:  Tighten the mounting nuts to 8 N.m (71 lb in).

  3. Install the EBCM assembly. Refer to Electronic Brake Control Module (EBCM) Replacement .
  4. Bleed the system. Refer to Hydraulic Brake System Bleeding (Manual) or Hydraulic Brake System Bleeding (Pressure) in Hydraulic Brakes.
scientia non olet · About Mike's Workshop Manuals