Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Hummer >> 2007 >> H3 Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 29 (Engine Control System - 3.5L (L52) - Introduction) >> Repair Instructions >> Camshaft Position (CMP) Sensor Replacement-Intake >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2005 GMC Canyon and 2005 Chevrolet Colorado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Intake CMP Sensor Engine Wiring Harness Connector
    GM1350719Courtesy of GENERAL MOTORS CORP.
  1. Disconnect the engine wiring harness electrical connector from the intake camshaft position (CMP) sensor.
    2. Fig 2: View Of Intake Camshaft Sensor
    GM858173Courtesy of GENERAL MOTORS CORP.
  2. Remove the intake CMP sensor retaining bolt.
  3. Remove the intake CMP sensor from the cylinder head.

    Discard the O-ring seal.

scientia non olet · About Mike's Workshop Manuals