Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Hummer >> 2007 >> H3 Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 16 (Engine Control System - 2.8L (LK5) - Introduction) >> Repair Instructions >> Camshaft Position (CMP) Sensor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2005 GMC Canyon and 2005 Chevrolet Colorado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of CMP Sensor Connector, Exhaust Camshaft Actuator Connector & Engine Wiring Harness Retainer
    GM1350714Courtesy of GENERAL MOTORS CORP.
  1. Disconnect the engine wiring harness electrical connector (4) from the camshaft position (CMP) sensor (5).
    2. Fig 2: View Of Exhaust Camshaft Sensor
    GM858172Courtesy of GENERAL MOTORS CORP.
  2. Remove the CMP sensor retaining bolt.
  3. Remove the CMP sensor from the cylinder head.

    Discard the O-ring seal.

scientia non olet · About Mike's Workshop Manuals