Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Hummer >> 2007 >> H3 Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 31 (Supplemental Inflatable Restraint System) >> Repair Instructions >> Inflatable Restraint Roof Rail Module Replacement - Front (Crew Cab) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2005 GMC Canyon and 2005 Chevrolet Colorado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Forward Curtain Clip & Air Bag Module Bolts (Crew Cab)
    GM1276868Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  1. Install the 3 bolts (1, 3) retaining the roof rail air bag module to the roof.

    Tighten:  Tighten the roof rail air bag module bolts to 9 N.m (79 lb in).

  2. Install the forward curtain clip (2).
  3. Install the bolt retaining the bracket to the roof.
    4. Fig 2: View Of Pillar Clips (Crew Cab)
    GM1276879Courtesy of GENERAL MOTORS CORP.
  4. Install the 3 bolts retaining the rear curtain to the roof.

    Tighten:  Tighten the roof rail air bag curtain bolts to 9 N.m (79 lb in).

    5. Fig 3: View Of Roof Rail Module Connector
    GM1276857Courtesy of GENERAL MOTORS CORP.
  5. Install the clips (3) to the pillar.
  6. Install the roof rail air bag forward tether bolt (3).

    Tighten:  Tighten the roof rail air bag forward tether bolt to 9 N.m (79 lb in).

  7. Connect the roof rail air bag electrical connector (1).
  8. Install the headliner. Refer to Headliner Replacement (Crew Cab) or Headliner Replacement (Extended Cab) or Headliner Replacement (Regular Cab) in Interior Trim.
  9. Enable the SIR system. Refer to SIR Disabling and Enabling Zone 2  and SIR Disabling and Enabling Zone 6 .
  10. Install the head restraints from the front seats. Refer to Head Restraint Replacement - Front Seat in SIR.
scientia non olet · About Mike's Workshop Manuals