Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Hummer >> 2007 >> H3 Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 17 (Battery, Charging System And Starting System) >> Repair Instructions >> Battery Negative Cable Disconnect/Connect Procedure >> Disconnecting Procedure

Disconnecting Procedure

WARNING: This page is about a different car, the 2005 GMC Canyon and 2005 Chevrolet Colorado. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: Batteries produce explosive gases. Batteries contain corrosive acid. Batteries supply levels of electrical current high enough to cause burns. Therefore, in order to reduce the risk of personal injury while working near a battery, observe the following guidelines:
  • Always shield your eyes.
  • Avoid leaning over the battery whenever possible.
  • Do not expose the battery to open flames or sparks.
  • Do not allow battery acid to contact the eyes or the skin.
    • Flush any contacted areas with water immediately and thoroughly.
    • Get medical help.
CAUTION: Before servicing any electrical component, the ignition key must be in the OFF or LOCK position and all electrical loads must be OFF, unless instructed otherwise in these procedures. If a tool or equipment could easily come in contact with a live exposed electrical terminal, also disconnect the negative battery cable. Failure to follow these precautions may cause personal injury and/or damage to the vehicle or its components.
  1. Record all preset and theft codes from the radio.
  2. Turn off all lamps and accessories.
  3. Turn the ignition switch to the LOCK position.
  4. Fig 1: View Of Battery Cables
    GM1313634Courtesy of GENERAL MOTORS CORP.
  5. Loosen the battery negative cable nut (2).
  6. Disconnect the battery negative cable (1) from the battery.