Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Hummer >> 2007 >> H2 4D Utility Pickup >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls And Fuel - 6.0L - Introduction (2 Of 2) >> Repair Instructions >> Camshaft Position Sensor Replacement >> Removal Procedure

Removal Procedure

IMPORTANT: Clean the area around the camshaft position (CMP) sensor before removal in order to prevent debris from entering the engine.
    Fig 1: View Of Camshaft Position (CMP) Sensor & Bolt
    GM260128Courtesy of GENERAL MOTORS CORP.
  1. Remove the engine sight shield. Refer to Upper Intake Manifold Sight Shield Replacement (6.0L (LQ4)) .
  2. Disconnect the CMP sensor electrical connector.
  3. Remove the CMP sensor bolt.
  4. Remove the CMP sensor.
scientia non olet · About Mike's Workshop Manuals