Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Hummer >> 2006 >> H2 4D Utility Pickup >> Repair and Diagnosis >> Steering >> Steering Linkage (Non-Rack & Pinion) >> Repair Instructions >> Steering Linkage Inner Tie Rod Replacement >> Installation Procedure

Installation Procedure

    Fig 1: Inner Tie Rods Ends
    GM865341Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
    IMPORTANT: Perform the following procedure before installing the new tie rod ends.
    • Remove all traces of the oil, grease, or other contaminants.
    • Clean the threads of the tie rod with denatured alcohol or the equivalent and allow to dry.
    • Apply Threadlocker GM P/N 12345493 or Canadian P/N 10953488 to the threads of the tie rod.
  1. Install the inner tie rod to the relay rod.

    Tighten:  Using the J 34028  (2) tighten the tie rod to 100 N. See Special Tools .m (74 lb ft).

  2. Install the outer tie rods. Refer to Steering Linkage Outer Tie Rod Replacement .
  3. Install the engine protection shield. Refer to Engine Protection Shield Replacement .
  4. Lower the vehicle.
  5. Verify the wheel alignment. Refer to Wheel Alignment Specifications .
scientia non olet · About Mike's Workshop Manuals