Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Hummer >> 2004 >> H2 4D Utility Pickup >> Repair and Diagnosis >> Steering >> Power Steering System >> Repair Instructions >> Power Steering Gear Inlet Pipe/Hose Replacement >> Installation Procedure

Installation Procedure

    Fig 1: Power Steering Gear Inlet Hose & Brake Booster
    GM793264Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Installing Hoses Without Twists or Bends Notice in Cautions and Notices.
  1. Route the hose in the same position the hose occupied prior to removal.
  2. Install the power steering gear inlet hose to the brake booster.
    3. Fig 2: Power Steering Gear Inlet Hose & Power Steering Gear
    GM793265Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the power steering gear inlet hose to the power steering gear.

    Tighten:  Tighten the power steering gear inlet hose fittings to 28 N.m (21 lb ft).

  4. Remove the drain pan from under the vehicle.
  5. Bleed the power steering system. Refer to Bleeding the Power Steering System .
scientia non olet · About Mike's Workshop Manuals