Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Hummer >> 2003 >> H2 >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transmission - Introduction, Removal & Installation & Service >> Repair Instructions >> Transmission Mount Replacement >> Installation Procedure

Installation Procedure

    Fig 1: Transmission Mount
    GM793590Courtesy of GENERAL MOTORS CORP.
  1. Install the transmission mount to the vehicle.
    2. NOTE: Refer to Fastener Notice .
  2. Install the bolts.

    Tighten:  Tighten the bolts to 60 N.m (44 lb ft).

    3. Fig 2: Identifying Transmission Mount Nuts
    GM647997Courtesy of GENERAL MOTORS CORP.
  3. Lower the transmission and install the two nuts securing the transmission mount to the transmission support.

    Tighten:  Tighten the nuts to 40 N.m (30 lb ft).

  4. Remove the transmission jack.
  5. Install the catalytic converter guard. Refer to Catalytic Converter Guard Replacement .
  6. Lower the vehicle.
scientia non olet · About Mike's Workshop Manuals