Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Hummer >> 2003 >> H2 >> Repair and Diagnosis >> External Pages >> Different car >> Section 622 (Rear Suspension System) >> Repair Instructions >> Rear Axle Lower Control Arm Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Lower Control Arm
    GM793290Courtesy of GENERAL MOTORS CORP.
  1. Install the lower control arm.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
    IMPORTANT: Do not tighten the bolts unless the suspension is at the curb height position.
  2. Install the lower control arm to axle bolt and nut.

    Tighten:  Tighten the bolt to 200 N.m (148 lb ft).

    3. IMPORTANT: Do not tighten the bolts unless the suspension is at the curb height position.
  3. Install the lower control arm to frame bolt and nut.

    Tighten:  Tighten the bolt to 155 N.m (114 lb ft).

  4. Remove the rear axle support.
  5. Lower the vehicle.
scientia non olet · About Mike's Workshop Manuals