Installation Procedure
WARNING: This page is about a different car, the 2004 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
- Support the lower control arms at curb height.
- Perform the following procedure before installing the bolts.
- Remove all traces of the original adhesive patch.
- Clean the threads of the bolt with denatured alcohol or equivalent and allow to dry.
- Apply Threadlocker GM P/N 12345382 (Canadian P/N 10953489).
- Install the link assemblies.
- Install the link bolts.
- Install the nuts to the link bolt assemblies.
Tighten: Tighten the nut to 14 N.m (10 lb ft).
- Ensure that the threads of the link bolt protrude 2 to 4 threads above the link nut.
- Lower the vehicle.